What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 08:51
the problem then depends on "how fast does the fuse operate?".
Now when you have a certain ac resistance, then a current flows in a loop.
Because the load is inductive, the current lags the voltage.(by a bit).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This one hit behind the barn.
An AC voltage/ current source, and an ac inductive load.
If Humans Become Extinct, This Is the Species That Will Take Over the Planet - The Daily Galaxy
eight
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
How to Cut Your Biological Age by Up to 16 Years: Make This Tweak to Your Daily Walk - Inc.com
First Sentence:
But it can get overloaded, and no longer works.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Paul vs. Chavez Jr. Results: Live updates of the undercard and main event - MMA Fighting
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
The bolt then partially travels down the line to your home.
The third is lightning and “how it gets conducted into a home.”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
What is lightning?
He then asserts :
Jurors in Harvey Weinstein trial reportedly fighting among themselves - BBC
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The MOV will conduct when the voltage exceeds 50% of line voltage.
These devices are installed between the “hot” and “neutral” and protective ground.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
a photo is worth a thousand words.
Barnstars:
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Terraforming Mars Might Actually Work and Scientists Now Have a Plan to Try It - ZME Science
so, what happens?
[old diagram got deleted by accident]
One is “what exactly is in a ‘surge protector’ ? ”
Why is the word "democracy" not in the preamble of the US Constitution?
It seems Mohan does not understand the difference between a comment and an Answer.
[image of Common-mode choke]
Edit 2024–10.
Ryu Ga Gotoku Studio's Project Century Gets A Strange New Title - GameSpot
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
I post the exact comment here.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
what exactly is a ‘surge’ protector?
This is 'the assistant's answer'
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This device then solves the entire problem.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Here is a simplified AC power diagram.
but I think this circuit , shows a few more pieces.
So, the voltage could go up to 500 volts, and the fuse will not open up.
In schematic diagrams this is the symbol for a fuse:
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is where the MOV conducts again, and dissipated the energy.
There are three different concepts here that are getting confused.
2024–10–16 [ OO OLAOYE OYEBODE ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But… the neutral is now “floating” because of the 1 ohm resistance.
At one ohm, the resistor has a maximum of 1 watt power.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
nine
What does a fuse do?
For this case there are devices called Metal oxide varistors (MOV).
At least they know the answer if they wanted it.
There are two important concepts here.
The other is “what does a “fuse” do?”
One
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
A circuit breaker is similar, but is resettable.
A fuse is a non-resetable over current circuit protector.
It also is a device that limits the change in current flow.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–10[John johnson John Johnson ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is where this question deviates from being a 'generic' question, and becomes more specific.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Can the fuse protect the electronic devices from lightning instead of a surge protector.
He then describes the function of a fuse.
(Dc diagram shown, AC is similar).
He then describes Rainy Season and Lightning.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
but this device (an Inductor) … impedes the rapid changes in the current.
Upvotes:
These are simplified answers to the original question, and does not change anything I wrote above.